User manual

22After sales support

802: No factory settings -> Send new Configsys file to your V4 embosser

810: Configuration - corrupt

811: Parameter - corrupt

812: Layout - corrupt

813: Header - corrupt

814: Network - corrupt

999: Restart

700: Ink timeout

701: Ink start up

702: Ink power up

703: Ink Power down

704: Ink post service

IPC = Internal Protocol for Communication between the Linux master CPU and the low lever

CPU controlling the stepper motors and hammers.

Spool file errors (200-299) press OK embosses without complete information, or press ON

to cancel the embossing.

Link to latest internet error list

6.4 Interfaces

The interfaces are located at the back side of the embosser.

Power input 48V DC

Reset/system reset button; press 3 seconds for system reset

Service serial port

LED yellow = paper sensor on Basic and Everest

LED green

Serial port

USB port

Network port

6.4.1 Reset and system reset

The reset button is located in the hole between the power in plug and the service serial interface.

Please use a narrow pin to reach the reset button.

Reset

Press the reset button abruptly. This command will reset the embosser. It will start up the

embosser and remove all Braille documents in the embosser in the same way as when the

embosser is powered off.

System Reset