User manual

21 Index V4 Embosser manual
© 2012 Index Braille
6.3 Error codes
ERROR - Table Firmware 1.3.9
100: IPC - Configure ->press OK to continue
101: IPC - Timeout ->press OK to continue
102: IPC - Restart ->press OK to continue
103: IPC - Clear queue->press OK to continue
120: Out of paper -> insert paper and press OK
121: Paper jam -> remove paper and press OK
122: Paper length fail
123: Paper tray empty -> insert paper and press OK
130: Service door open
131: Paper tray open
132: Braille tray open
133: No tray / door signal open
134: Braille tray full (Braille Box)
135: Paper jam - release
200: Spool file - error
201: Spool file - empty
202: Spool file - unknown esc sequence
203: Spool file - WinBraille esc sequences not supported
210: Spool file - V3 format esc sequences not supported
204: Spool file - XML-document
205: Spool file - HTML-document
206: Spool file - post script file
210: Spool file - V3 format
211: Spool file - V2 format esc sequences not supported
212: Spool file - min value for parameter in esc sequence exceeded
213: Spool file - max value for parameter in esc sequence exceeded
214: Spool file - max characters per line exceeded
215: Spool file - max lines per page exceeded
216: Spool file - to many transparent characters
220: Spool file - unknown parameter
299: Spool file - formatting error
300: Not a valid file, checksum error
301: Not a valid magic number
302: Not a valid header
500: Undefined hardware setup
501: Undefined software setting
502: Free memory error
503: Large document error
504: Large document error
800: No SD-memory available
801: SD-memory Read only ->press OK -> power on restart -> not OK change SD card