User manual

15 Index V4 Embosser manual
© 2012 Index Braille
3.3.3 Double feed
If the sheet feeder feeds several sheets at a time, please check:
Good cut sheet paper quality with a minimum weight of 120 gsm
Move the sheet/card selectors upward, both right and left selector to the same position, until
the papers are separated correctly
3.3.4 Braille output adjustment
1.
Adjust the white document guide to 10 mm (1/2") from paper edge.
2.
Adjust the angle on the lower document profile for best paper out functioning.
3.3.5 Maintaining
Complete service information is available at www.indexbraille.com
3.3.5.1 Clean pick-up rollers
The pick-up roller surface will become less sticky after some time, due to the typical aging
process of rubber. The original sticky surface may be recovered by:
a) Cleaning with a rubber cleaning liquid, characteristically used in copy machines.
b) Grinding with very fine sand paper
- Hold the sandpaper against the pick up roller.
- Rotate the rollers by pressing Form Feed followed by On Line for more movement until the
surface is sticky.
- Repeat this with the other pick-up rollers.
3.3.5.2 Clear paper jam
Power off the embosser.
Check where the paper is jammed.
Open the Braille out aluminum profile.
Remove the paper manually by rotating the paper rollers.
If paper is jammed inside the embossing head and not possible to remove this way please do the
"Clear major paper jam" actions described in the V4 Service Manual.
3.4 Braille Box
Braille Box supports cut sheet paper of the formats: A4, A3, Letter 11x8.5 inch, 11x17 inch and
11x11.5 inch