User's Manual

Connection to External equip-

ment

VCR Setup

- In Video mode, TV automatically reverts to TV mode if the CH

button or number buttons are pressed.

Connection 1

Set VCR switch to 3 or 4 and then tune TV to the same channel num-

ber.

Connection 2

1. Connect the audio/video output jacks on VCR to the corresponding

input jacks on the TV. When connecting the TV to a VCR, match the

jack colors (Video = yellow, Audio Left = white, and Audio Right =

red).

2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer

to the VCR owner’s manual.)

3. Use the INPUT SELECT button on the remote control to select AV1

or AV2. (If connected to S-VIDEO on side panel, select the S-Video

external input source.)

Cable TV Setup

- After subscribing to a local cable TV service and installing a converter,

you can watch cable TV programming.

- For further cable TV information, contact a local cable service provider.

Connection 1

1. Select 3 or 4 with channel switch on cable box.

2. Tune the TV channel to the same selected output channel of cable box.

3. Select channels at the cable box or with the cable box remote control.

Connection 2

1. Connect the audio/video output jacks on Cable Box to the corre-

sponding input jacks on the TV. When connecting the TV to Cable

Box, match the jack colors

(Video = yellow, Audio Left = white, and Audio Right = red).

2. Use the INPUT SELECT button on the remote control to select AV1

or AV2.

3. Select channels with the cable box remote control.

S-VIDEOS-VIDEO

AC INPUTAC INPUT

AV1V1

AV2V2

ANTANT. IN

Typical Antennas

VCR

Direct

Connection

Cable Box