User Manual

4.5.4 Standard Configuration

A. Other Essential System Components necessary to perform Digital

Radiography

 Yushan (Supporting SDK Interface) can be used in combination with the

image processing unit provided by System Integrator.

 The X-ray equipment is composed of X-ray high voltage generator and

X-ray console, etc. The hand switch is connected with the console for the

exposure. At first, when making an exposure, press the Prep switch only

of the hand switch. After confirming that the X-ray equipment is ready

System Integrator of X-rays, press the Exp. switch of the hand switch.

 The Access Point is required system, when Yushan is used in wireless

communication mode.

B. A standard configuration of this device is as below.

 Yushan (Supporting SDK Interface):

Flat panel sensor : Yushan V14C / V14G / V17C / V17G

The control software is installed and used in a Windows PC (the image

processing unit) prepared by the System Integrator.

This variation provides images, which diagnostic image process is not

implemented, to the image processing unit.

An X-ray automatic detection function is used for Yushan V14C / V14G / V17C

/ V17G. This function could detect a start timing of an X-ray exposure using

readout signals in the detector. After detecting the start timing of the X-ray

exposure, the detector starts collecting of X-ray signals and image readout.