User Manual

© Inno
Care Optoelectronics
_____________________________________________________________
Caution
_____________________________________________________________
4.1.4
Charging the Battery Pack for the Flat Panel
Detector
Use the battery charger recommended by
details on operations, refer to the instruction manual for the battery charger.
4.1.5
Installing/Removing the Battery Pack for the Flat
Panel Detector
Follow the procedure below to install/remove the bat
detector.
When installing/removing the battery pack, place the flat panel
detector on a flat place.
Do not remove the battery pack until a processed image appears in the
window of the image processing unit after the exposure.
Do not place the c
on a hard surface such as
the edge of a bed.
Care Optoelectronics
Corporaon │ X-
Ray Products
_____________________________________________________________
_____________________________________________________________
Charging the Battery Pack for the Flat Panel
Use the battery charger recommended by
Inn
oCare Optoelectronics Corp.
details on operations, refer to the instruction manual for the battery charger.
Installing/Removing the Battery Pack for the Flat
Follow the procedure below to install/remove the bat
tery pack for the fl
When installing/removing the battery pack, place the flat panel
Do not remove the battery pack until a processed image appears in the
window of the image processing unit after the exposure.
Do not place the c
onnector
on a hard surface such as
the edge of a bed.
Make sure that the connector
does not protrude from the
edge of a bed.
Do not raise the flat panel
sensor by holding only the
connector
36
Ray Products
_____________________________________________________________
_____________________________________________________________
Charging the Battery Pack for the Flat Panel
oCare Optoelectronics Corp.
. For
details on operations, refer to the instruction manual for the battery charger.
Installing/Removing the Battery Pack for the Flat
tery pack for the fl
at panel
When installing/removing the battery pack, place the flat panel
Do not remove the battery pack until a processed image appears in the
Do not raise the flat panel
sensor by holding only the
connector
.