Owner's Manual

Golden Tee
®
Online Home Edition Version 10/17 Page 27
© Copyright 2017 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
Sound Problems
Symptom
Probable Cause
Solution
No audio
Audio Cable between the I/O Board
and the Nighthawk system box are
not connected.
Verify audio cables are connected.
Refer to Appendix D.
Volume is set to the lowest level.
Adjust the volume to an audible
level.
Attract mode sounds may be set to
all off. You will have sounds when
playing the game.
Choose one of the 5 Attract Mode
sound options in Sound
Adjustments.
Defective I/O Board.
Verify on a known working system.
Replace if necessary.
Defective Nighthawk system box.
Be certain all other possibilities are
explored before replacing the
Nighthawk system box.
DIP switch settings are incorrect for
your application
Refer to Monitor Applications at the
back of this manual for proper
setup.
Bad speaker.
Replace blown speaker.
Distorted or scratchy game audio
Loose speaker or grill cover is
causing vibration.
Verify all components are installed
properly and securely.
Loose/defective audio cables from
the Nighthawk system box to the
I/O Board.
Check the audio cable connections.
Replace cable.
Defective I/O Board.
Verify on a known working system.
Replace if necessary.
Defective Nighthawk system box.
Be certain all other possibilities are
explored before replacing the
Nighthawk system box.
Nighthawk System Box Problems
Symptom
Probable Cause
Solution
No video and no green lights on
the I/O Board. Fans are not heard
on the Nighthawk System Box.
No AC power to the Nighthawk
System Box.
Verify A.C. voltage is connected to
the Nighthawk System Box.
Power switch on the Nighthawk
System Box is off.
Flip the Nighthawk System Box
power switch to on.
Main cabinet power switch is off.
Be certain the main cabinet switch is
set to on.
Soft Power Shutdown
Press the Soft Power button with the
power turned on. Or, short the top 2
pins of the 6-pin connector on the
system box. See Appendix D.
Defective Nighthawk System Box.
Be certain all other possibilities are
explored before replacing the
Nighthawk System Box.
No video and no green lights on
the I/O Board. Fans are heard on
the Nighthawk System Box.
DC power cord not connected from
Nighthawk System Box to I/O
Board.
Connect the DC power cord from the
Nighthawk System Box to the I/O
Board.
Defective I/O Board.
Try it on a known good system.
Verify by disconnecting all cables
from the I/O Board except the DC
power and USB cable to the
Nighthawk System Box. No green
lights, replace the I/O Board.