Owner's Manual

Golden Tee

Online Home Edition Version 10/17 Page 9

Cabinet Identification Device (CID)

This device contains a specific ID number that identifies your cabinet. The CID is a permanent number and must

be connected to the main system box via the USB cable and working properly in order for the game to operate.

CID Removal and Replacement

If for some reason you must replace the CID, disconnect the USB cable from the CID. This is the only connection

to the CID. Next, remove the four ¼” wood screws that secure the CID to the interior left side of the cabinet (as

you face the game). The CID is located above the I/O Board. To install a CID, mount the CID in the proper

location using four ¼” wood screws. The CID should be mounted so the USB port is facing the top of the cabinet

and the electronics are facing the wall.

CARD READER

The Card Reader is a very important aspect to Golden Tee,

and is very important to keep in good working condition.

Players are required to use a card to identify themselves for

most of the online features. If the card reader is not working

properly, these features will not be available.

Card Reader Installation

Unlock the control panel and open to expose the interior of the

Showpiece cabinet. With a nut driver, attach the four 11/32”

nuts that mount the card reader. Attach the USB cable to the

card reader.

Card Reader Removal

Unlock the control panel and open to expose the interior of the

Showpiece cabinet. Remove the USB cable from the card

reader. With a nut driver, remove the four 11/32” nuts that

mount the card reader. The card reader can now be pulled

away from the front of the cabinet.

Note: The Cabinet Identification Device should NEVER be removed from the cabinet, even when replacing any of the other

components. The CID is the cabinet’s PERMANENT Identifier, regardless of any other components.

Lock

The lock on the rear of the Showpiece cabinet allows access to the Nighthawk system box under the control

panel.

Service Button

Mounted under the outer edge of the Showpiece cabinet are controls for System Setup. Reach under the rounded

ledge on the front right side of the cabinet and press the red button to access the game’s System Setup software

menu system. The System Setup menus cover a variety of important areas including tests, game adjustments,

and optional settings.

CONTROL PANEL

Opening the control panel provides access to all game controls and hardware components. To open the control

panel, simply use the supplied key in the lock on the back of the cabinet and lift from the back. The control panel

is hinged in front and will stay open when fully extended.

Soft Power Switch

A “soft power” switch has been added to the underside of the control panel, to assist in the update process. This

switch will turn off power to the cabinet so you don’t have to reach around to the main power switch located on the

back of the cabinet.

Note: If you turn power off using the Soft Power Switch, you must use this same switch when turning power back on.