Installation and Assembly Instructions

Showpiece™ Stand Manual Page 7 of 8 Ver 0109 www.itsgames.com
© 2009 Incredible Technologies All rights reserved
Step 4:
Attach Vertical & Marquee Brackets to HDTV
Carefully place your HDTV screen face down on a
flat, smooth, and clean surface. A soft cloth or sheet
is recommended to prevent scratching the screen.
The Vertical Brackets have been designed to work
with most hole patterns found on HDTVs. If the holes
on your HDTV do not line up with the vertical
brackets, do not use this stand.
Place the Vertical Brackets on the back of the HDTV
and align to the proper mounting holes. The
Brackets should be evenly spaced from the center of
the back of the screen.
Align the two Marquee Brackets (supplied with
Showpiece Cabinet) with the holes at the top of the
Vertical Brackets. Select the proper hole on the
Marquee Bracket that best suits your display. Use a
Phillips screwdriver to attach the appropriate supplied
screws. Be sure all of the brackets are straight and
secure.
Once positioned, attach the
vertical brackets with the
appropriate combination of
screws and washers designed
for your screen. Tighten
screws so the brackets are
firmly secured, but take care
not to overtighten or stress
your hardware.
Note: The number of
fasteners used will vary
depending on the type and
size of screen. Washers may
not be needed depending on
the type of screen. Screw
sizes vary from screen to
screen. Be sure to use the
correct screw size
recommended by your TV
manufacturer. Always use the
top and bottom holes on the
screen to secure the brackets.