Installation and Assembly Instructions

Table Of Contents

Showpiece™ Stand Manual Page 6 of 8 Ver 0109 www.itsgames.com

Step 2:

Attach the Monitor Plate to Mounting Poles

Lay the two Vertical Poles on a

clean flat surface, about 4 ¼" apart.

Place the Horizontal Monitor Plate

on top of the poles. The flat surface

on the plate should be flush with the

poles. The small tabs on the ends

of the plate should face up.

Align the 4 holes on the plate with

the top 4 threaded holes on the

poles. Secure the plate to the poles

using the supplied 5/16-18 x ½" Hex

Screws and lock washers, using a

½" hex driver. Be sure the screws

are tightened securely. Do not over

tighten.

NOTE: If you wish to mount your monitor lower to the ground, attach the monitor plate

to the lower sets of screw holes on the poles.

Step 3:

Attach Pole Assembly to Base Beams

Carefully lift the pole assembly and insert the

bottom ends of the tubes into the pipe sleeves

on the Base Beams. The vertical poles should

rest on the floor.

Make sure the monitor plate is level and

parallel to the Showpiece cabinet.

Insert the four ¼-28 x ½" screws and secure

the poles to the Base with a 7/16" hex socket

or open end wrench