User Manual

Stainless Steel
6” x 3” Precision
X-Y Marker
Put YOUR Mark on Precision
Micro-fine
guide holes
locate your
mark exactly
on target.
When accuracy counts … INCRA RULES !
A NEW Concept in Precision Steel Rules
Measures from two perpendicular
edges in one operation
Locate drill centers fast and easy
Great for positioning cabinet door
knobs and handles
One or both T-Bars can be removed for
single edge referencing or flat work
To mark with a 0.5mm
Mechanical Pencil: Just hold the
pencil vertically and twist the
pencil in a hold to mark a dot.
To mark with a Wooden Pencil:
First, sharpen the pencil, then
twist the lead once or twice in any
one of the holes to give it an ultra
fine point ready for marking.
To mark with a Metal Scribe or
Center Punch: Any scribe or
center punch sharp enough to fit
through the holes can be used.
Use finger pressure ONLY to mark
a precisely located “dimple” in soft
materials such as wood, paper,
plastic, brass or aluminum.
DO NOT damage your precision
rule by pounding the point
through the hole with a hammer.
For marking: Place the X-Y Marker
on your workpiece against two edges of
any square corner, then make your mark
by twisting a .5mm pencil or sharp
metal scribe in any one of the holes.
Adjusting the T-Bar:
Your X-Y Marker comes fully
assembled. If you ever loosen
the thumbscrews, be sure to
place the end of the Marker
firmly against the indexing lip
on the T-Bar before retightening
to insure perfect accuracy.
Manufactured by:
Taylor Design Group, P.O. BOX 810262, Dallas, TX 75381
INCRA is a Registered Trademark of Taylor Design Group, Inc.
© 2010 Taylor Design Group, Inc.
www.incra.com