Manual

MAINTENANCE

In general, just keeping your INCRA JIG clean is all you need to do to keep the tool in tip top shape. Occasionally, remove the

carriage from the base and brush or blow out any sawdust or debris that may have accumulated on the base and the UHMW

guide bearing strips. Use a toothbrush to clean the teeth on the INCRA racks on both the carriage clamp and on the carriage.

SYMPTOM PROBABLE CAUSE SOLUTION

Micro adjusting knob will not Carriage clamp is not "unlocked" Carriage clamp must be pushed down to the "unlock"

rotate or is difficult to rotate. position and the micro adjust lever must be pressed

down to place the jig in the micro adjust mode. See

page 7, Steps 1- 4.

Jig is micro adjusted to end of the Micro adjust back to mid-range position as indicated by

forward travel range. the micro adjust range scale. (Turn knob counter-

clockwise until "0" on the scale is aligned with the left

end of the micro adjusting knob.)

Micro adjusting knob rotates Micro adjust lever not engaged. After "unlocking" the carriage clamp the micro adjust

but no movement of the lever must be pushed down to place the jig in micro

carriage or fence. adjust mode. See page 7, Steps 1- 4.

Jig micro adjusted to end of Micro adjust jig forward to mid-range as indicated by

backward travel range. the micro adjust range scale. (Turn knob clockwise

until "0" on the range scale is aligned with the left end

of the micro adjust knob.

After placing jig in micro Micro adjust range scale not Realign micro adjust range scale. See page 18.

adjust mode, the micro properly aligned.

adjusting knob will not turn

even though the range scale

indicates travel range

available.

Carriage clamp squeaks Carriage clamp pivot pin needs Remove the carriage from the base, then remove the

when clamping or lubrication (6) phillips head wood screws that secure the ULTRA

unclamping base to your plywood subbase. Turn the ULTRA's

base upside down and you'll see where the carriage

clamp pivot pin passes through the clamp handle.

Apply a thin coat of light grease to the pivot pin using a

small cotton swab then remount the ULTRA base to

your plywood. See page 4, Fig. 1.

/8" thick carriage clamp pad Apply a thin coat of light grease to the carriage

needs lubrication. clamp pad.