Owner's manual

6 each
3
⁄8 – 16 x 1
1
⁄2”
hex bolt
6 each
3
⁄8”
flat washer
6 each
3
⁄8”
lock washer
6 each
3
/8 – 16
hex nut
2 each
3
⁄8 – 24 x 1”
hex bolt
(Delta Unisaw)
4 each
5
⁄16 – 18 x 1
1
⁄2”
hex bolt
4 each
5
⁄16”
flat washer
4 each
5
⁄16”
lock washer
4 each
5
⁄16 – 18
hex nut
 Before using the INCRA TS-LS, read and follow all
of the instructions and safety information in this
manual.
 When using the INCRA TS-LS in conjunction with
any other tool, first read and follow all instructions
and safety information in that tool’s owner’s manual.
 Never let any part of the INCRA TS-LS interfere
with another tool’s safety guards or other safety
equipment.
 Before using your INCRA TS-LS, make sure all
mounting screws are tight and that the black
clamping knobs are securely tightened to the rails.
 Always turn off the power and make sure that the
blade is fully stationary before changing the setting
on any part of the INCRA TS-LS.
 Always keep both hands behind the fence when
moving the INCRA TS-LS to a new setting.
 Before making a cut, always make sure that the
carriage clamp is fully engaged and that the
rail hook thumbscrew is securely tightened.
 Use appropriate safety devices. Keep hands clear
of the saw blade! Always use a push stick, rubber
soled push block, or other safety devices to keep
your hands safely away from the saw blade.
 Never let the saw blade come into contact with
any part of the INCRA TS-LS or LS Positioner.
 Wear safety glasses, hearing protection, and follow
all normal shop safety practices.
 Never operate your table saw without a blade guard.
SAFETY
FASTENERS
(ACTUAL SIZE)
Mounting Bracket Hardware Pack B-01
Note:
Extra hardware is provided in this pack to
ensure compatibility with a wide variety of
table saws. Only four of the bolts will be
used in a typical installation.
Important safety instructions for using the INCRA TS-LS
2 INCRA Woodworking Tools & Precision Rules