Instruction Manual

INCRA Build-It STS Mortiser Manual
Page 4
6. Cut the right angle supports and faceplate
stops to the dimensions shown in Fig. 12.
All (4) pieces have identical dimensions.
Drill a
5
/16” diameter hole through (2) of the
pieces and set aside for later use as faceplate
stops.
Glue up the right angle faceplate assembly, placing
the right angle supports about
1
/4” away from
the edge of the base, Fig 13.
Fig.12
Right Angle Supports and Faceplate Stops
Fig.14
Attach Faceplate Assembly to Build-It Platform
7. Secure the right angle faceplate assembly to your Build-It
Platform using (2)
1
/4-20 x 1-
1
/2” hex bolts with washers and
clamping knobs as shown in Fig. 14.
Slide the slotted base of the faceplate assembly up to the T-
Track Fence and tighten the clamping knobs. Attach the (2)
faceplate stops to the assembly using (2)
1
/4-20 x 1-
1
/2” hex
bolts with washers and clamping knobs, Fig 15.
Fig.13
Glue Faceplate Assembly
Fig.15
Attach Faceplate Stops
5
/16” dia
hole (2)
4”
4”
2
1
/4”
right angle supports
1
1
/8”
1
1
/8”
faceplate stops
4”
1
/4” approx.
base
right
angle
support
faceplate
faceplate
assembly
1
/4”
-
20 x 1
1
/2”
hex bolts
Build-It Platform
45°
90°
1
/4”
-
20 x 1
1
/2”
hex bolts