Installation & Assembly

Important

DO NOT place unit on its side or back as

it will compromise its structural integrity.

THIS SIDE UP

1 2

3 4

Carefully remove the 3M protective layer,

insert alignment pin to connect back

and side zBoards.

Carefully remove the rest of the 3M protective layers.

Place alignment pins in vertical zBoards.

Connect the horizonal zBoard with the

assembled back and side zBoards.

Easy, done! Maximum weight capacity 30 pounds.

Visit links below for more details.

Enjoy building possibilities!

2 Side zBoards

adhesive strips on 2 edges

1 Horizontal zBoard10 Pins

2 Back zBoards

adhesive strips on 2 edges

Included

WARNING: CHOKING HAZARD

Small parts NOT for children under 3 years

MONITOR STAND

• Assemble your unit on a ﬂat even surface, carpet not recommended

• Furniture is for indoor use only

Watch and Assemble Help and Comments Share and Win

• When moving your furniture, lift from the bottom• Make sure

zBoard surfaces are clean and dry

PAGE 1
MONITOR STAND • Assemble your unit on a ﬂat even surface, carpet not recommended • When moving your furniture, lift from the bottom • Make sure • Furniture is for indoor use only zBoard surfaces are clean and dry Included 10 Pins 2 Back zBoards adhesive strips on 2 edges 1 Horizontal zBoard 1 Carefully remove the 3M protective layer, insert alignment pin to connect back and side zBoards. 2 Carefully remove the rest of the 3M protective layers. Place alignment pins in vertical zBoards.