INSTRUCTION MANUAL
ASSEMBLY GUIDE Congratulations, you are now the owner of a brand new chair! To best enjoy the comfort of the chair, you have to put it together first! This assembly guide will take you through the assembly process. To make sure the assembly goes well, please follow the instructions, and especially the important safety information. It is possible to assemble the chair on your own, but it is recommended to have a second person to make it easier and safer.
Package List Without further ado, we kindly suggest you to list all parts needed for the chair first.
Assembly Instruction Step 1: (11)×2 Turn the Base (7) upside down, then insert Detachable legs (6) one by one into the Base. Use the Wrench (12) to screw ten Bolts (11) into the pre-drilled screw holes to fix the Base and the Base Legs. 1 (7) (6) 2 (5) Step 2: (8) Press the Casters (8) into the holes at the end of each Base Leg. And then insert the Gas Lift (5) into the center hole of the Five-Star Base.
Step 3: (9)×4 Align the Mechanism (4) over the pre-drilled holes underneath the Seat Cushion (2). Then fix it with the Bolts (9). (4) Note : Don't make the direction wrong, make sure the front of the mechanism is facing the front of the Seat. (2) 4 Step 4: (10)×2 (10)×2 3 Insert Seat Cushion (2) into the Gas Lift (5), fix the right and left Armrest (3) with the Bolts (10).
5 Step 5: (1) Use the Wrench (12) to screw Two Bolts (10) into the pre-drilled screw holes to fix Backrest (1). (10) 6 (10) (10) Step 6: Fix the Backrest (1) with another two Bolts (10) vertically, screw all of bolts and make sure all of them are tight fully. CAUTION: Make sure all bolts and screws are fully tightened before using chair. Lubricate all moving parts and tighten all bolts/screws every 6 months or whenever needed.
Instructions For Use 1. Seat Height: Paddle-shaped lever on the right side To raise: While taking your weight off chair, lift lever up. To lower: While seated, lift lever up. * At the proper height, your feet should rest flat on the floor. 2. Operating the rocking function To let your chair tilt back, pull the control handle out. To stop your chair from tilting, sit forward, then push the control handle in.
3. Tilt Tension: Long stem under the seat with knob + - To increase tension: While seated, turn knob forward (Counter clockwise). To decrease tension: While seated, turn knob backward (Clockwise ). * Set the tilt tension to control the resistance you feel when leaning back.
Safety And Maintenance Do not stand on the chair, Do not use the chair as a stepladder. Use this product for seating one person at a time. Do not use the chair unless all bolts and screws are firmly secured. Avoid contact with sharp objects to prevent puncturing the fabric. Every 6 months, check all bolts and screws to ensure they are tight. To clean, spot clean only using a damp towel and mild cleaner, first test on a small, unseen area of fabric. Chair weight limit not to exceed 250 lbs.
Limited Warranty The producer promises to repair or replace any chair that is found to be defective in material or workmanship within one(1) and year from the date of original purchase so long as you, the original purchaser, still owns it. This is your sole and exclusive remedy. This warranty is subject to the provisions below. EXCLUSIONS: This warranty does not apply and no other warranty applies to: Normal wear and tear, which are to be expected over the course of ownership.
