INSTRUCTION MANUAL
ASSEMBLY GUIDE Congratulations, you are now the owner of a brand new ergonomic chair! To best enjoy the comfort of the chair, you have to put it together first! This assembly guide will take you through the assembly process. To make sure the assembly goes well, please follow the instructions, and especially the important safety information. It is possible to assemble the chair on your own, but it is recommended to have a second person to make it easier and safer.
Package List Without further ado, we kindly suggest you to list all parts needed for the chair first.
Assembly Instruction Step 1: (13)×2 Turn the Star Base (9/a) upside down, then insert legs (8) one by one into the Star Base. Next, screw ten Bolts (13) into the pre-drilled holes with the Wrench (16) to attach the base and legs. a 1 (9)a (8) b 2 (9)b (5) (6) Step 2: Press the Casters (6) into the holes at the end of each Base Leg. And then insert the Gas Lift (5) to the base. Next, insert the plastic cover (9/b) to the Gas Lift (5).
3 (10)×4 Step 3: Turn the Seat Cushion (2) upside down and align two holes on one of the Armrests (3) with the pre-drilled holes under the Seat Cushion. Attach the Armrest to the Seat Cushion with two Bolts(10) using the Wrench (16). Repeat on the other side of armrest. (2) (3) Note : No difference on left and right armrests to make fast installation.
5 Step 5: Turn the Seat Cushion (2) upright and align the center hole of the Seat Plate over the Gas Lift, then push the Seat Cushion down into the Gas Lift firmly until the connection is secure. 6 (11)×4 Step 6: 1 (7) Attach the Steel Plate(7) and Back Cushion with Four Bolts (11), and assemble the Back Pillow. CAUTION: Make sure all bolts and screws are fully tightened before using chair. Lubricate all moving parts and tighten all bolts/screws every 6 months or whenever needed.
Step 7: Attach the Seat Cushion (2) and Back Cushion (1) with three Bolts (12), please adjust the balance of each sides, then tighten all bolts with Wrench (16).
Instructions For Use 1. Seat Height: Paddle-shaped lever on the right side To raise: While taking your weight off chair, lift lever up. To lower: While seated, lift lever up. * At the proper height, your feet should rest flat on the floor. 2. Backrest Recline Pull the lever FULLY and lean back SLOWLY until desired angle is achieved, then slowly return the lever to its starting position, ensure the lever locks back in place.
3. Recliner for Rest Pull out the pole of the footrest, and turn the footrest to the front.
Safety And Maintenance Do not stand on the chair, Do not use the chair as a stepladder. Use this product for seating one person at a time. Do not use the chair unless all bolts and screws are firmly secured. Avoid contact with sharp objects to prevent puncturing the fabric. Every 6 months, check all bolts and screws to ensure they are tight. To clean, spot clean only using a damp towel and mild cleaner, first test on a small, unseen area of fabric. Chair weight limit not to exceed 250 lbs.
Limited Warranty The producer promises to repair or replace any chair that is found to be defective in material or workmanship within one(1) and year from the date of original purchase so long as you, the original purchaser, still owns it. This is your sole and exclusive remedy. This warranty is subject to the provisions below. EXCLUSIONS: This warranty does not apply and no other warranty applies to: Normal wear and tear, which are to be expected over the course of ownership.
