Owner Manual

Instruction
12
Amend the desktop height displayed
Keep pressing key“S”till the display show“A - - ”alternately.
·
Keep“Up”or“Dn”several times,till the display show“End”and height.
(In this case, the unit is mm or inch when this system's metric or imperial)
·
Press“1”,“2”and“3”respectively, and to adjust the first number,
the second number and the third number.If you click one,the number will
increase by 1, till you get to the value you want.
·
Press“S”the height has been changed to defined digit.
·
·
Note: The function enables you to change the height shows on the display based on the
actual measurement.
·
Restore factory setting
Keep pressing "S" till the display shows "FAC".
·
Press "S",and the control unit to factory setting (including memory position,
container-and shelf-stop position,etc).
·
·
Plug detection
·
The function can detect whether the motors
are collected normally
Once the display shows“E-3”and“rES”，it reminds you check whether
any motors fail connected with control unit. Please connect the main cable
again,wait at least 5 seconds.
·
Connect all the plugs.
·
Follow “Manual Reset ”procedure.
With this functin,you can make the control
unit to factory setting.
1.
2.
3.
1.
2.
2.
3.
5.
4.
S
S
1 2
S
S
2
E-3 rES
rES
Keep pressing down key till the desktop till display shows“E-1”and“rES”
alternately and release the key.
1.
▲
·
rES
▲
▲