Owner Manual
Table Of Contents
Instruction
11
·
Anti-Collision function
Before use, please make sure removing obstacle
in advance and human body is in the safe position.
Once the desktop encounters any obstacle in its path, the screen
displays“E-2”。
·
The desktop will move a defined distance in opposite direction, and it
would be used normally after removing the obstacle.
·
·
·
·
Container and self-stop positions
·
Do not enable this function only when you
are really need in some situation.
Keep pressing the key“S”for 3 seconds till the display shows“S--”to
enter setup menu.
·
Press up key till the display flash as“HLP”.
·
Press“1”，the display show alternately as“H-P”and current height.
Note: By this function would be used to limit the movement area of desktop, when the container
is underneath or any shelf above the desktop. Once it is set, the new upper or lower limitation
will be stored.
·
Keep pressing up or down key till the required upper limit position is
reached.
·
Press“S”,the desktop height will be showed and the shelf stop position
has been set.
·
Press “2”, the display will show altemately “L-P” and current height,
keep pressing down key till the lower limit position is reached, press “S”,
the container stop position has been set.
·
Keep pressing key“S”till the display show“S--”to enter the setup menu.
Press “UP”key,the display will show“Unt”.
·
Press“1”，and the display will show alternately as“Unt”and the desktop
height unit by“cm”.
Press“S”key to save the unit as cm.
·
Press“2”，and the display will show alternately as“Unt”and the desktop
height unit by“inch”,press key“S”to save the unit as inch.
·
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
1.
S
▲
▲
▲
S
1
2
S
▲
S
1
2
E-2
HLP
H-P
L-P
Unt