Owner Manual

BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
❶ Do a quick inventory to
make sure the package
contains all the parts and
hardware listed in the
assembly instructions.
❼ To avoid misalignments, always leave the
screws loose and
tighten them until all
pieces are positioned
correctly.
❷ Missing, damaged
and defective parts can be
replaced at no cost to you.
Please refer to the last
pages on this manual.
❽ Do not overtighten or
force the screws as they
might break, strip,
damage the threads of
the holes or get stuck
inside the part.
❸ The replacement parts
service is limited to the
continental United States.
If you reside in Alaska,
Hawaii, Puerto Rico,
U.S. Dependencies or other
countries, please contact the supplier
from where the unit was purchased.
❾ Sometimes the laminate might cover partially
or entirely the hole on a panel. If there is no
visible hole for the screw, pass and press the tip
of your finger over the area where the hole
should be located to feel the indentation, and
once found, carefully pierce the laminate to
reveal the hole underneath.
❹ If during assembly you
find an issue or need
clarification, please
contact our Customer
Service for assistance.
Please refer to the last
pages on this manual.
❺ On each step read the
instructions and analyze the
illustrations thoroughly
before proceeding to do the
assembly.
❿ If the hole seems too small for the screw, first
make sure you are using the correct size of
screw and that it’s been installed in the correct
hole. If the hole still appears to be too small,