INSTRUCTION MANUAL
ASSEMBLY GUIDE Congratulations, you are now the owner of the new chair! Before enjoying the comfortable chair, you have to assemble it . This assembly guide will take you through the basic assembly process. To make sure your assembly progress goes smoothly, please follow the assembly instructions especially the important safety information. It is possible to assemble the chair by your own, while having a second person to help you will make it easier.
Package List Without further ado, we kindly suggest you to list all parts needed for the chair first.
Step 1: Assembly Instruction Turn the Base (7) upside down, and then insert the Legs (8) one by one into the Base. (10)×2 1 (7) Next, screw ten Bolts (10) into the pre-drilled holes with the Wrench (13) to attach the base and the legs. (8) 2 (5) Step 2: Press the Casters (6) into the holes at the end of each Base Leg. And then insert the Gas Lift (5) to the base.
3 Step 3: Align the Mechanism (4) over the pre-drilled holes underneath the Seat Cushion (2), make sure the front of the mechanism is facing the front of the Seat. Attach the Mechanism to the Seat Cushion using Four Bolts (11), tighten all the bolts with the Wrench (13), being careful not to miss-thread the bolts or damaged the seat.
(1) Step 5: Lay the Back Cushion on the seat of the chair with the top of the cushion toward the front. Attach the Back Cushion (1) to the Arms by inserting one Bolt (12) in the Lower holes with the Wrench (13). 5 50% (12) 6 Step 6: 100% (12) 100% Rotate the back of the chair up, then secure it with the Bolts (12) use the Wrench (13). Adjust the balance on each side of the chair, and fully tighten all the bolts at this step.
(9) Step 7: 7 Press the Headrest (9) into the Headrest Bracket firmly. CAUTION: Make sure all bolts and screws are fully tightened before using chair. Lubricate all moving parts and tighten all bolts/screws every 6 month or whenever needed. Instructions For Use 1. Seat Height: Paddle-shaped lever on the right side To raise: While taking your weight off chair, lift lever up. To lower: While seated, lift lever up. * At the proper height, your feet should rest flat on the floor.
2. Tilt Tension: Long stem under the seat with knob + - To increase tension: While seated, turn knob forward (Counter clockwise). To decrease tension: While seated, turn knob backward (Clockwise ). * Set the tilt tension to control the resistance you feel when leaning back. 3. Operating the rocking function To let your chair tilt back, pull the control handle out. To stop your chair from tilting, sit forward, then push the control handle in.
Safety And Maintenance Do not stand on the chair, Do Not use the chair as a stepladder. Use this product for seating one person at a time. Do not use the chair unless all bolts and screws are firmly secured. Avoid contact with sharp objects to prevent puncturing the fabric. Every 6 months, check all bolts and screws to ensure they are tight. To clean, spot clean only using a damp towel and mild cleaner, first test on a small, unseen area of fabric. Chair weight limit not to exceed 270 lbs.
Limited Warranty The producer promises to repair or replace any chair that is found to be defective in material or workmanship within one(1) and year from the date of original purchase so long as you, the original purchaser, still owns it. This is your sole and exclusive remedy. This warranty is subject to the provisions below. EXCLUSIONS: This warranty does not apply and no other warranty applies to: Normal wear and tear, which are to be expected over the course of ownership.
