Installation & Assembly (48 H x 55 W x 28 D)

INSTALLATION
3
6
4
5
8
7
5
OPERATION
M6×10 (x4)
B
5×16 (x12)
4×15 (x4)
D
E
S=4mm
Press and display real height
Press and display real height
Press until 1 appears, release the button, it runs
to corresponding height and displays current position.
Press until 2 appears, release the button, it runs
to corresponding height and displays current position.
Over-heating
protection
Sensorless
alarm
Overload
protection
Rebound
protection
Overvoltage
alarm
Undervoltage
alarm
Step out alarm
Breaking
protection
Conversion
between
metric and
British system
Hot: it alarms when continuous working 2 minutes;
clear automatically after resting 18 minutes.
E10: It alarms when motor hall value cannot be
inspected; clear it after press reset or re-power on.
E20: overload alarm when running up, clear automatically
after 3 seconds; overload alarm when running down,
clear it after press reset or re-power on.
E02: it alarms in reversed compression when running;
clear automatically after rebound 4cm; or press any
button to clear when rebounding.
E32: it alarms when voltage is higher than limit value,
clear automatically after voltage reduced to set value.
E31: it alarms when voltage is lower than limit value;
clear automatically after voltage is higher than set value.
E60: it alarms when height difference between left and
right leg exceeds the set value; clear it after re-power on.
It stops and enters protection state when motor lines or
manual control lines are removed or disconnected
accidentally; back to normal after reconnected and alarm
cleared.
Press button with 3 seconds, and the screen shows
"S--" and flickers; Press S button again and functionality
will be shown. Use and switch to ( ) which will
show the preset height data. Use to switch between
opitons( 、 ). Press "S" button and keep 2 seconds
to save current option.
Protection mode (auto lock screen mode)
Save button,used to enter the save height function
After press , the interface flashes and set memory
position, press until H1 appears, release button and
it displays current height.
Reset
Memory
Position
Long press for 5 seconds, display RES and press
still, it goes down to the lowest and rebound certain
height, reset finish and show basic height.
S
S
S
5×16 (x12)
D
G
S=2mm
I