Owner Manual
6. Toggle the display unit format
Step Operation Motion
1 Press and hold button S, then press and hold
, keep about 6 seconds
The height information will be changed between centimeters and inches
2 Release the buttons completed
In inch format, the minimum height variation as the legs move up or down is 0.5 inches, while in centimeter format is 1 centimeter
7. Verify the display switch data to table height
Step Operation Motion
1 Set the table at any height, recommended at
the bottom position
Measure the table actual height and write down the number in inches or in
centimeters
2 Press and hold button S, then press and hold
Ʒ, keep about 6 seconds
The first number is flashing on the screen
3 Release the buttons, then click Ʒor to
change the first number
The first number is being increased or decreased to the first number you
measured
4 Click button S The second number is flashing on the screen
5 Click Ʒor to change the number The second number is being increased or decreased to the second number you
measured
6 Click button S The third number is flashing on the screen
7 Click Ʒor to change the number The third number is being increased or decreased to the third number you
measured
8 Click button S Completed
Check the switch display format in inches or in centimeters and toggle to the unit you like and match to the actual measurement. In inch format, the
minimum adjustable height is 0.5 inches, while in centimeter format is 1 centimeter.
8. Lock the bottom stroke limit
Step Operation Motion
1 Press and hold Ʒor, then release Run the legs to the position you want the table surface to be
2 Press and hold button S, then press and hold 1,
keep about 6 seconds
Letter “L” is indicated on the screen. That means the position is locked at the
lowest position that the table can be moved to
3 Release the buttons Completed
1.Legs aren’t able to run below the locked position
2.Memory position(s) are/is below the locked position will lost even after the table is unlocked, you need to follow SET MEMORY POSITIONS again to
reset these memory positions
3.Initialize switch will not unlock the top limit.
9