USER MANUAL I N A LTO. H O US E Built-in Grill 4/6 Burner — MODEL CODE /S IBBQBI4B/IBBQBI6B A HIGHER LEVEL OF COOKING V.
WELCOME PAGE 02 Welcome Residentia Group Pty Ltd ACN. 600 546 656 165 Barkly Avenue Burnley, Victoria Australia 3121 — Applico Ltd 635 Great South Road Penrose, Auckland 1061 New Zealand Congratulations on purchasing your new appliance! The InAlto brand is proudly distributed within Australia by Residentia Group Pty Ltd and within New Zealand by Applico Ltd.
CONTENTS 02 04 06 08 12 19 21 22 23 24 WELCOME U SE OUTDOORS ONLY INSTALL ATION INSTRUCTIONS CLEANING & MAINTENANCE PURCHASE DETAILS SAFE T Y INSTRUCTIONS YOUR INALTO BBQ TECHNICAL DATA TROUBLESHOOTING WARRANTY INFORMATION
USER MANUAL PAGE 04 Safety Instructions Your safety is of the utmost importance to us. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Retailer where you purchased your unit from. The appliance should only be installed and connected by a suitably qualified and authorised person, strictly in accordance with the manufacturer's instructions.
PAGE 05 INALTO.HOUSE DECLARATION OF CONFORMITY FOR OUTDOOR USE ONLY This appliance complies with the following European Directives and Australian Standards: — AGA Certificate No. 8138 ► PLEASE READ THE INSTRUCTIONS CAREFULLY AND BE SURE YOUR BARBECUE IS CORRECTLY INSTALLED AND ASSEMBLED.
USER MANUAL PAGE 06 Use Outdoors Only This appliance shall only be used in an above ground openair situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any outdoor enclosure in which the appliance is used shall comply with one of the following: ► An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover. See Figure 1.
PAGE 07 INALTO.HOUSE GAS CYLINDER INFORMATION This appliance is designed to be used with a gas cylinder not exceeding (Australia 9KG) ► The gas cylinder supply valve must be turned off when the appliance is not in use. ► Gas cylinders must be stored outdoors, out of reach of children and must not be stored in a building, garage or any other enclosed area. ► The gas cylinder used must incorporate a safety collar to protect the valve assembly.
USER MANUAL PAGE 08 Your InAlto BBQ SPECIFICATIONS IBBQBI4B 20mm / 50mm 873mm / 903mm IBBQBI6B 20mm / 50mm 1173mm / 1203mm
PAGE 09 INALTO.HOUSE SIDE VIEW: IBBQBI4B / IBBQBI6B BUILT IN INSTALLATION WARNING THE CONSTRUCTION OF THE ENCLOSURE AND INSTALLATION OF THE BBQ SHOULD BE CARRIED OUT ONLY BY AUTHORISED PERSONS. THE BARBECUE MUST ALSO BE SECURED TO THE ENCLOSURE TO PREVENT IT BEING PULLED OUT AND STRAINING THE GAS CONNECTIONS. ► Please follow these instructions for installation. Any other requirements of AS/NZS 5601.1, local authority, or relevant statutory regulations, and ensure adequate ventilation.
USER MANUAL PAGE 010 PART LIST & EXPLODED VIEW — IBBQBI4B PART # DESCRIPTION QTY PART # DESCRIPTION QTY 1 Warming Rack 1 14 Ignition cable 4 2 Stainless steel cooking grid 1 15 Control Knob 7 3 Cast iron flat plate 1 16 Igniter (1 for 5) 1 4 Flame diffuser 4 17 Knob bezel with blue LED 7 5 Screws (M5) 4 18 Light /LED Switch 1 6 Light cover 2 19 Grease tray 1 7 Screw 2 20 Foot 4 8 Light 2 21 Cable for light 1 9 Temperature gauge 1 22 Cable for LED
PAGE 01 1 INALTO.
USER MANUAL PAGE 12 Installation Instructions ASSEMBLY INSTRUCTIONS: IBBQBI4B WARNING Ensure all transit protection is removed prior to assembly. 4 Cooking grid (No.2)/plate (No.3) assembly 1 Foot (No.20) assembly 5 Warming rack (No.1) assembly 2 Built in supporting bracket assembly (No.24.25) 3 Flame tamer (No.4) assembly 6 Grease tray (No.
PAGE 13 INALTO.HOUSE ASSEMBLY INSTRUCTIONS: IBBQBI6B 1 Foot (No.20) assembly 4 Cooking grid (No.2)/plate (No.3) assembly 2 Built in supporting bracket assembly (No.24.25) 5 Warming rack (No.1) assembly 3 Flame tamer (No.4) assembly 6 Grease tray (No.
USER MANUAL PAGE 14 ASSEMBLY INSTRUCTIONS: IBBQBI4B or IBBQBI6B 7 Battery is require for ignition Battery (Battery is not included) 8 Transformer (for BBQ lights / LED) ► AssemblyTransformer needs to be installed and fixed where it is located well away from high temperatures. ► The transformer must be always kept dry.
PAGE 15 INALTO.HOUSE NATURAL GAS CONVERSION WARNING 1 Conversions only to be done by an Authorized person 2 A restraining tether or bracket is required to be fixed to the appliance and to the wall within 50mm of each connection point. The length of the tether shall not exceed 80% of the length of the natural gas hose assembly.
USER MANUAL PAGE 16 4 . Reassemble the burner. （3） （4） 3. With the burner removed, you will see the brass gas jet which is screwed into the end of the valve. Using the socket driver supplied, unscrew the end LPG jet while retaining the inner (NG) jet. Note: Please make sure the gas valve is located well inside the main burner tube when re-installing the burners. 5. Repeat the above steps for the other main burners.
PAGE 17 INALTO.HOUSE INSTRUCTIONS FOR CONVERTING THE BACK BURNER 1. Remove the back burner cover (3) (4) 2. Remove the LPG jet from the elbow shaped brass injector assembly.
USER MANUAL 3. Reassemble the plates as removed. 3. Disconnect the cable 4. Replace a new light and re-assemble PAGE 18 Instruction to replace the LED light 1. Take off the control knob and unscrew the knob bezel BARBECUE LIGHT & LED 2. Take off the unit and disconnect the cable 3. Replace a new one and re- assemble WARNING Always keep the plug in dry condition. Instruction to replace the barbecue lights 1. Take off the light rear cover 2.
PAGE 19 INALTO.HOUSE Technical Data Model No.: IBBQBI4B Gas Type Universal LP Gas & Natural Gas Universal LP Gas Natural Gas Test Point Pressure 2.75KPA 1.0KPA Main Burner (injector size) 0.98mm 1.50mm Back Burner (Injector size) 0.98mm 1.65mm Total Nominal Gas Consumption (MJ/h) 64.5 57 Main Burner Nominal Gas Consumption (MJ/h) 13×4 11×4 Back Burner Nominal Gas Consumption (MJ/h) 12.5×1 13×1 AC Adaptor Input: 230-240VAC, 50Hz Output: 12VAC 2000mA Cord: 250V, 10A Model No.
USER MANUAL PAGE 20 Rating Labels Model: IBBQBI4B AGA Certificate No. 8138 Serial No.: Gas Type: – Universal LP Gas – Natural Gas Test Point pressure: ULPG- 2.75kPa / NG -1.0kPa For Electrical Components AC Adaptor – Input: 230-240VAC, 50Hz – Output: 12VAC 5000mA Cord: 250V, 10A OUTDOOR U S E O N LY FOR USE WITH UNIVERSAL GAS Gas Type: ULPG IF IN NEED Burner Gas Consumption Injector Main 13×4 (MJ/h 0.98mm Back 12.5×1 MJ/h 0.
PAGE 21 INALTO.HOUSE Cleaning & Maintenance All cleaning and maintenance should be carried out when the barbecue is cool and with the fuel supply turned OFF at the gas cylinder after each use. ► D O NOT mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should NEVER be painted). Apply a strong solution of detergent and water or use a grill cleaner with brush on insides of grill lid and bottom.
USER MANUAL PAGE 22 Troubleshooting Please read the issues below carefully and try all relevant steps. If none of this helps, please contact us for further advice or to schedule a technician to inspect your BBQ. Tips & Hints THE BURNERS WON'T LIGHT THE BURNER FL AMES ARE SLOW TO START Please check... That your BBQ is plugged in and there is power to the wall socket. Please check... The burner parts may be blocked with water or another substance. Please contact our Support Team for advice.
PAGE 23 RECEIPT INALTO.HOUSE Purchase Details For future reference, please record the following information which can be found on the rating plate and the date of purchase which can be found on your sales invoice. STORE DETAIL S STORE NAME | ADDRESS | TELEPHONE | PRODUCT DETAIL S MODEL NO. | SERIAL NO.
USER MANUAL PAGE 24 Warranty Information AUSTRALIAN WARRANTY TERMS & CONDITIONS BBQ APPLIANCES This document sets out the terms and conditions of the product warranties for Residentia Group Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1.
PAGE 25 INALTO.HOUSE 5. You will bear the cost of transportation, travel and delivery of the Appliance to and from Residentia Group or its ASR.
This page is intentionally left blank
Warranty Information NEW ZEALAND WARRANTY TERMS & CONDITIONS BBQ APPLIANCES To help care for your investment, be sure to register your appliance online. Registration will help you if you need to arrange service in the future, and serves as a record of your purchase – including critical information like model number and serial number – that you can refer to at any time. Simply visit the below website, or ask your retailer for help: www.inalto.
— W W W. I N A LT O.
