User Manual

08
Thr
ough your wall
Installation Instructions\\\
Further to y
our various ducting options, below are some tips on how to
correctly duct your rangehood:
– Alway
s use correctly sized ducting – DO NOT reduce the size of the ducting
– Alway
s use solid ducting
– Alway
s use non-flammable ducting
– Alway
s duct to the outside atmosphere
– Do not use fle
xible ducting
– Do not duct int
o the ceiling space- always vent to the outside atmosphere.
– Avoid sharp 90 degr
ee bends as much as possible, use 45 degree bends
instead wherever possible
– Duct to the outside atmospher
e using the shortest duct run possible
– Use cylindrical ducting whene
ver possible
Positioning the rangehood
Installation heigh
ts
– Over gas and electric cookers, R
esidentia Group recommends our
rangehoods to be mounted at a height of between 600-800mm above the
cooking surface.
– Electric cooktops mus
t have a minimum height of 600mm from the
underside of the rangehood to the cooktop face.
– Gas cooktops mus
t have a minimum of 650mm from the burner to the
underside of the rangedhood.
– Over open flame grillers or barbecues, the Gas Regula
tions require the
filters of the rangehood to be at least 1200mm above the cooking surface.
Installing the rangehood
Important! . if you need the safety screws fixed into the hood,please mark ,
drill and tighten the hood with screw plug and screw(ST4mm X 30mm),you
will need to remove the grease filters first.( See Pic E )
Wall plug
W
all b
racket
Holes on wall
Exhaus
t pipe
Cooker hood
Screw
(ST4 x 30mm)
Warning: Failure to install the screws or fixing device in accordance
with these instru
ctions may result in electrical hazards.
The warning shall be in the same part of the instructions that include
details of how to mount the equipment.
Deter
mine your installation height , drill 3 holes to install the wall bracket
with 3 x Wall Plugs and 3 x Screw ST4x30mm onto the wall ensuring that
it is secured in a level position . (SEE Pic A)
When finish, hang the hood onto the hook. (SEE Pic A)
Attach the extensible 200mm tube to the hood. (SEE Pic B)
Fix the chimney bracket with the chimney with 2 x Screw ST4x8mm
(SEE Pic C)
Attached the chimney to the hood , mark and drill 2 holes to fix
the bracket on the wall. (SEE Pic D)
–
–
–
–
–
MM
AIH60W
MM
AIH90W
*Screw*
(ST4 x 30mm)
Cabinet
Pic A
Pic B
(ST4 x 8mm)
*Screw*
Pic C
2222Wall plug
*Screw*
(ST4 x 30mm)
2×
2×
Pic D
(ST4 x 30mm)
*Screw*
2×
Pic E