User's Manual

22 Copyright © 2018 InCoax Networks AB. All rights reserved.
Confidential under NDA
Figure 23 — The Add VLAN page.
Table 9 — Description of the Add VLAN parameters.
Term
Value
[Default Setting]
Definition
S-VLAN 1 - 4095 802.1q VLAN ID.
C-VLAN 1 - 4095 C-VLAN is the VLAN tag the customer is using on their own devices.
Prio [0] - 7 The VLAN priority between 0 and 7.
OPT82 ID 1 - 4095
If the DHCP snooping is activated the VLAN ID information uses the value
in this field.
DHCP Snooping
[Inactive]
Active untrusted
Active trusted
- DHCP Snooping is inactive.
- Uses OPT82 and rewrites the value.
- Uses OPT82 and keeps the value.
OPT82 Circuit ID
Modem mac
Controller mac
Controller vlan
Modem id
Controller id
[Blank]
Choose the source for the value to set CID field in DHCP option 82.
OPT82 Remote ID
Modem mac
Controller mac
Controller vlan
Modem id
Controller id
[Blank]
Choose the source for the value to set RID field in DHCP option 82.
PPPoE Enabled Yes/[No]
If PPPoE is enabled all upstream PPPoE-frames will have the Vendor
specific option 0x105 added with Remote ID set to the value that is
configured in the field "DHCP OPT82/PPPoE ID” of the Access Modem
configuration.
Multicast VLAN Yes/[No]
Broadcasts the IGMP queries to all configured VLANS, i.e. Multicast VLAN
Registration (MVR) MVLAN is configured on this VLAN. Then the other
VLANs intended to be MVR receiver VLANs can be configured by adding
multicast groups to the MVR receiver VLAN multicast configuration.
Please note that the Source VLAN has to be set to the MVLAN. When an
MVLAN is configured, the VLAN will carry traffic for the configured
multicast groups.
It is possible to configure multiple MVLANs on a switch, but they must
have disjoint multicast groups. An MVR receiver VLAN can be associated
with more than one MVLAN, by configuring multicast groups for the MVR
receiver VLAN.
Internal VLAN Yes/[No] The Controller tags untagged traffic with this VLAN ID.
Add VLAN Click to add the new VLAN.
Reset Click to discard the settings.