User's Manual

20 Copyright © 2018 InCoax Networks AB. All rights reserved.
Confidential under NDA
Figure 19 — Trunk and Coax ports.
Figure 20 — The default settings for the Trunk port.
Table 7 — Description of the Trunk port parameters.
Term
Value
[Default Value]
Definition
Port Speed
TRUNK 10G, COAX 4×2.5G /
TRUNK 1G, COAX 4×1G
[TRUNK 10G, COAX 4×2.5G]
”TRUNK 10G, COAX 4×2.5G” sets the Trunk port to work in 10 Gbps
mode and the Coax ports to run in 2.5 Gbps mode. The setting is
intended to be used with 10 Gbps Ethernet SFP+ modules and
10 Gbps XG(S) - PON ONT/ONU that support 10 Gbps Ethernet.
”TRUNK 1G, COAX 4×1G” sets the Trunk port to work in 1 Gbps mode
and the Coax ports to run in 1 Gbps mode. The setting is intended to
be used with 1 Gbps Ethernet SFP modules and 1 Gbps GPON
ONT/ONU that support 1 Gbps Ethernet. The reason for setting the
Coax ports to 1 Gbps is that there is no reason to support higher
speeds than the Trunk port supports.
Apply Click to apply the settings.
Reset
Click to discard the settings.
Figure 21 — The default settings for the Coax ports.