User's Manual
Copyright © 2018 InCoax Networks AB. All rights reserved. 19
Confidential under NDA
3.4.2.1
Add Multicast
Click on the
ADD MC GROUP
to add a new multicast group.
1. Configure the relevant parameters Multicast group IP, Name, Source VLAN, and Reserved bandwidth, as
seen in
Figure 17
and
Table 6
.
2. Click on
Add multicast group
to save the settings and add the new Multicast Group.
Figure 17 — Add Multicast.
Table 6 — Description of the Multicast parameters.
Term
Value
Definition
Multicast group IP Multicast IP address.
Name User defined name.
Source VLAN 1 - 4095
Enter the Source VLAN for the multicast group, if multicast VLAN
registration is used. See also Multicast VLAN in section 3.4.4.
Reserved
bandwidth
The reserved bandwidth on the link for this group. The reserved
bandwidth for the multicast group is deducted from the unicast capacity
of each Modem, i.e. each Modem that gets the distributed multicast
traffic.
Add multicast
group
Click to add the new multicast group.
Reset Click to discard the settings.
3.4.2.2
Edit a Multicast Group
To edit one of the Multicast groups you can click on the IP address and you will be redirected to a page similar
to the one in
Figure 18
. Here you can edit all of the parameters found in
Table 6
except the IP address. Click on
the button
Apply
to save the settings.
Figure 18 – Edit Multicast Group.
3.4.3
Port Settings
The Controller has four coaxial ports and one SFP/SFP+ Trunk port for a connection to an Ethernet aggregation
network, as shown in
Figure 5
. The SFP/SFP+ Trunk port can support 1 Gbps and 10 Gbps speeds and must be
configured manually to either 1 Gbps or 10 Gbps. All coaxial links are by default activated on the band A - D at
1150 MHz by default. See
Table 7
and
Table 8
for more details.
1. In the main menu, hover over
MANAGEMENT
and click on
PORTS
.
Figure 19
shows the corresponding web
page.
2. Click on one of the
Settings
to change the settings for the specific port. See
Figure 20
and
Table 7
for more
details about the Trunk port and
Figure 21
and
Table 8
for more details about the coax ports.
3. Click on the button
Apply
to save the settings.