User's Manual

16 Copyright © 2018 InCoax Networks AB. All rights reserved.
Confidential under NDA
Table 4 — Description of the Add Service parameters.
Term
Value
[Default Setting]
Definition
Basic Settings
Name
User defined Name
[Blank]
Text string describing the Service. This can be changed when the
Modem has been added.
Service active On/Off [Off]
Defines which service that is active via SET function in the MODEM -
OVERVIEW tab. (See Figure 6.)
Service VLAN n id
n= 1 - 4
User added VLAN
Defines which of the VLANs are available on the Controller that could
be available for the Modem.
DHCP Option 82 User defined DHCP Relay Agent Information Option parameters.
DHCP Max Clients User defined
Defines max. concurrent clients that are allowed to connect to this
Modem.
Admission Allowed On/Off [On]
Defines whether the Modem is allowed to be associated with the
Controller or not. Check the checkbox to allow admission.
Automatic Power
Control
On/Off [On]
Enable or disable automatic power control. The benefit with automatic
power control is that the risk of interfering with other analogue devices
is reduced due to overall lower transmit power levels. External
interference problems can be reduced / avoided by disabling the
power control mechanism. Power control is enabled when the
checkbox is checked.
Power 0 - 10 [10]
This parameter sets the transmit power level when automatic power
control is disabled and sets the max. power level when automatic
power control is enabled. Each reduction in the index is a 3 dB
reduction in the transmit power level.
Power Control Rate 0 - 2048 Mbps [680]
This parameter is the required physical bit rate that will be targeted in
the automatic power control mode.
PA/Attenuation [Off/Off] Amplified output and/or attenuated input. (Default Off/Off).
US Speed limit 0 Max. upstream traffic from Modem.
MoCA Band [A - D] Choose frequency range. Options A - A/A - B/A - C/A - D or A - E.
Frequency (1 of]
450 - 1625 MHz
[1150]
The centre frequency the Modem is to operate on.
QoS (Q0 - Q3)
Upstream peak
0 - 2000 Mbps
[2000]
Max. unicast upstream traffic per queue.
Upstream guaranteed 0 - 2000 Mbps [100] Guaranteed unicast upstream traffic per queue.
Downstream peak
0 - 2000 Mbps
[2000]
Max. unicast downstream traffic per queue.
Downstream
guaranteed
0 - 2000 Mbps [100] Guaranteed unicast downstream traffic per queue.
Burst peak 0 - 131071 [80000] Burst traffic peak value.
Burst guaranteed 0 - 131071 [4096] Burst traffic guaranteed value.
Switch Configuration
VLAN passthrough [On]
If it is marked it means that each port allows packets with tagged VLAN
(defined in each Modem) to pass through the Modem switch. If it is not
marked, then packets with VLAN tag (other than defined in native) are
dropped.
Enable port On/Off [On] Activate/disable switchport.
Native VLAN (U) Service VLAN 1 - 4 id
Packets belonging to the VLAN specified here will leave the switch port
untagged and packets received on this port will leave the switch tagged
with this VLAN.
Tagged VLAN Service VLAN 1 - 4 id
Packets belonging to the VLAN specified here will leave the switch port
tagged and tagged packets (with this VLAN) received on this port will
leave the Controller tagged.