User's Manual

19
21
20
22
13 17
15
14
16
18
11
12
Led status
LED
Status
Remark:
When the battery level is low, the LED will not turn on until the
Pendant is charged up, which may takes several minutes.
1x1 Sec. Blue
1x2 Sec. Blue
1x3 Sec. Blue
Blinking red
Red LED on
Red LED off
Red/Blue Blinking
Red & Blue on simultaneously
Paired and connecting to BT device
Battery low (Max 15 Minutes left)
Under charging
Fully charged
Pairing-mode
Call waiting mode
Talking
Ready can be accessed by paired devices
Trouble shooting guide
No sound from mobile phone
1.Please check battery is powered.
2.Please check Pendant is turned on.
3.Please check your hearing aid is in T-coil mode or T-coil
+MIC mode.
4.Please check your mobile phone status.
Weak sound
1.Please check battery is powered.
2.Please check your mobile phone volume level and
mobile phone network signal is sound.
Maintenance and care
1.Keep the Pendant out of the reach of children
2.Store the Pendant is dry condition
3.Do not expose the Pendant to excessive moisture,
humidity or steam.
4.Avoid dropping or knocking the Pendant.
5.Avoid electric shock by keeping the Pendant away from
water.
6.Do not clean with harsh chemicals,cleaning solvents or
abrasive detergents.To clean,wipe with soft cloth slightly.
7.Do not leave the Pendant exposed to direct sun light or
other sources of heat
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio commun-
ications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This marking indicates that this product should
not be disposed with other household wastes
throughout the EU. To prevent possible harm to
the environment or human health from uncontr-
olled waste disposal, recycle it responsibly to
promote the sustainable reuse of material
resources. To return your used device, please
use the return and collection systems or contact
the retailer where the product was purchased.
They can take this product for environmental
safe recycling.
Correct Disposal of this product
In-Tech Electronics Ltd
Unit A, 13/F, Wing Tai Centre, 12 Hing Yip Street,
Kwun Tong, Kowloon, Hong Kong.
The following manufacturer is responsible for this declaration:
Declaration of Conformity
We,
Company: IN-TECH ELECTRONICS LTD.
With our,
Product(s): BLUETOOTH NECKLOOP PENDANT
Model No.: CS8140
herewith confirm to comply with the requirements set out in the
Council Directive on the Approximation of the Laws of the Member
States relating to the R&TTE Directive (1995/5/EC) as well as to the
Low Voltage Directive 2006/95/EC. For the evaluation of above
mentioned Directives, the following standards were applied:
EMC
EN 301 489-17 V1.3.2 (2008-04)
EN 301 489-1 V1.8.1 (2008-04)
EN55022: 2006
EN61000-3-2: 2006
EN61000-3-3: 1995+A1+A2
EN50371:2002
EN 300 328 V1.7.1 (2006-10)
LVD EN 60950-1: 2006 + A11: 2009
FCC Caution:
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate this equipment.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. End users must follow
the specific operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC RF exposure
compliance requirements, please follow operation instruction as
documented in this manual.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.