User Manual

ManualsBrandsIn Tech Electronics ManualsAudio EquipmentBluetooth Headset

UB 22S USB Dongle and BT 28VM Headset

Voice Over Internet Protocol (VOIP) Application

Bluetooth Bluetooth

2. Install IVT BlueSoleil application from the CD-ROM provided in the UB 22S

package. Note that the CD-ROM is not available in the BT 28VM package.

3. Download from the corresponding websites and install MSN messenger, Netmeeting,

Yahoo messenger, or ICQ application software in the PC.

4. Connecting and Disconnecting: The UB 22S Dongle will ring the BT 28VM Headset.

Please press the S1 key on the headset to confirm the connection request. To

disconnect the link, press the S1 key again. You can now pair and

reconnect your BT 28VM Headset to your mobile phone, if you desire.

5. Testing the Link: After the UB 22S Dongle is paired with the BT 28VM

Headset, the PC audio will be automatically routed to the " Audio"driver.

Play some music on the PC by Windows Media Player or other music applications; you

should be able to hear the music on the Headset. If you can't hear it, then go the

"control Panel"-> "Sound and Audio Device Properties"-> "Audio"-> "Sound playback"

select the " Audio"to activate the link.

6. Now you can start using the VOIP application and talk to your friend through your

headset wirelessly and freely.

Plug the UB 22S USB Dongle (purchased separately) into the USB socket of

aPC.

Pairing: Put the BT 28VM Headset into "pairing" mode by following the

steps in the BT 28VM User Manual, start the BlueSoleil application and pair the UB

22S Dongle with the BT 28VM Headset. The Headset passkey is "0000

Connecting BT 28VM Headset back to your mobile phone. Please

follow the steps from 'Putting Headset in Pairing Mode' to Establishing Link' on

page 7.

Bluetooth

Bluetooth Bluetooth

Bluetooth

1) Detach the ear hook from the headset

2) Select the orientation you want (left or right), and attach the ear hook and lock it

Bend the ear hook to fit your ear

Low-battery indication

The HS LED will flash red instead of orange when the battery is low.

There will also be a short beep every few minutes. When the battery level is too low,

the

will automatically power off.

1. Put on the headset with the ear hook behind your ear.

2. Bend the ear hook gently to fit your ear.

Notice: Make sure the microphone is pointing towards your mouth.

DISCLAIMER: Talk time and stand-by time of the BT 28VM Headset will vary depending on

mobile phone model being used

Bluetooth

Putting way

Ear Hook orientation

If you want to change the orientation of ear hook, please follow the following steps.

6 9

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

FCC Caution: Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

IMPORTANT NOTE:

FCC Radiation Exposure Statement: