User Manual

ManualsBrandsIn Tech Electronics ManualsAudio EquipmentBluetooth Headset

PART NO

MCB-8059050-0B

.: MODEL

CS 120

DRAWN:

Lucy

DATE:

02/02/2007

PAPER SIZE:

UNIT:

SCALE:

11:

:DESCRIPTION

#USE MANUAL

In Tech Electronics Ltd-.

! Bend the ear hook to fit your ear

1. Put on the headset with the ear hook behind your ear.

2. Bend the ear hook gently to fit your ear.

Notice: Make sure the microphone is pointing towards your mouth.

DISCLAIMER: Talk time and stand-by time of the BT 25EM Headset will vary depending

on mobile phone model being used

Bluetooth

! Putting way

Low-battery indication

Charging and recharging the battery

The HS LED will flash red instead of blue when the battery is low.

There will also be beep periodically. When the battery level is too low, the HS will

automatically power off. It cannot be powered on again unless the charger is

connected.

To recharge the battery, connect the charger cable to the HS. During recharging,

the LED shows a steady red light.When the battery is fully charged, the indicators

of red will be off.

ACAdaptor

AC Mains

Car charger

! Charging Connection

(2) Car charging

(1) A/C charging

NOTE

BQB CE and FCC approved

UB 22S USB Dongle and BT 25EM Headset

Voice Over Internet Protocol (VOIP) Application

Bluetooth Bluetooth

Plug the UB 22S USB Dongle (purchased separately) into the USB socket of

aPC.

Install IVT BlueSoleil application from the CD-ROM provided in the UB 22S

package. Note that the CD-ROM is not available in the BT 25EM package.

Download from the corresponding websites and install MSN messenger, Netmeeting,

Yahoo messenger, or ICQ application software in the PC.

Pairing: Put the BT 25EM Headset into pairing mode by following the steps

in the BT 25EM User Manual, start the BlueSoleil application and pair the UB 22S

Dongle with the BT 25EM Headset. The Headset passkey is 0000

Connecting and Disconnecting: The UB 22S Dongle will ring the BT 25EM Headset.

Please press the S1 key on the headset to confirm the connection request. To

disconnect the link, press the S1 key again. You can now pair and

reconnect your BT 25EM Headset to your mobile phone, if you desire.

Testing the Link: After the UB 22S Dongle is paired with the BT 25EM

Headset, the PC audio will be automatically routed to the Audio driver.

Play some music on the PC by Windows Media Player or other music applications; you

should be able to hear the music on the Headset. If you can’ hear it, then go the

ontrol Panel -> ound and Audio Device Properties -> udio -> ound playback

select the Audio to activate the link.

Now you can start using the VOIP application and talk to your friend through your

headset wirelessly and freely.

Connecting BT 25EM Headset back to your mobile phone.

Please follow the steps from ‘Putting Headset in Pairing Mode’ to ‘Establishing

Link’ on page 2.

Bluetooth

luetooth

Bluetooth Bluetooth

Bluetooth

cS AS

“”

“”“ ”“”“ ”

“”

270.00 mm

200.00 mm

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. End users must follow the specific operating instructions

for satisfying RF exposure compliance.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.