Operators Manual Instruction Manual
800-446-7488 5 www.in-situ.com
Overview
The TROLL Link Telemetry System provides quick and reliable remote
communications using a GSM/GPRS or satellite network.
TROLLLink 100 systems require user-configuration of the telemetry, and setting a
unique address for each instrument installed in the network. Users must set up a
wireless service plan with a cellular service provider or In-Situ Inc.
TROLL Link 101 systems are pre-configured by In-Situ Inc., but still require setting a
unique address for each instrument installed in the network. In-Situ Inc. sets up a
wireless service plan for the user.
TROLL Link 201 systems pre-configured by In-Situ Inc., but still require setting a unique
address for each instrument that is installed in the network. In-Situ Inc. sets up a
wireless satellite service plan for the user.
Unpacking and Inspection
All TROLL Link Telemetry Systems contain the following items.
l TROLL Link enclosure with mounting brackets
l Battery (12 V, 7 Ah)
l Antenna
l Solar panel (1W, 10W or 20W), cable with female disconnects (2), and mounting
bracket
l U-bolts (3), flat washers (6), split-lock washers (6), and nuts (6), or hex nut hose
clamps (2).
You need to supply the following items.
l Mounting pole or tripod with a diameter of 6.032 cm (2.375 in.)
l In-Situ Inc. instruments and appropriate RuggedCable systems
l TROLL Com Communication Device
l TROLL Link Setup Software*
l Win-Situ 5 Plus Software*
* Software can be installed from an In-Situ software CD or downloaded from www.in-situ.com/TelemetrySoftware
For TROLL Link 100 Systems, you need to supply the following additional items.
l SIM card (purchased from In-Situ Inc. or your service provider)
l Cellular service plan
l Email gateway phone number (3-digit number needed to send data to an email
address - obtained from your service provider)