Manual

800-446-7488 19 www.in-situ.com
Converter
Power Connections
The red wire provides power for all system modes. Analog output is disabled by default.
However, the 4-20 mA current loop output can be continuous in Modbus or SDI-12
mode as long as Modbus device register 9507 is set to 1.
Communications
The device automatically switches between Modbus and SDI-12 modes depending on
which of the two interfaces has activity. Modbus and SDI-12 cannot be used at the
same time—whichever one is currently in use will block communication on the other.