HM10 Bluetooth Module Datasheet

HM Bluetooth module datasheet
-------------------------------------------------------Last Version V507 2013-08-23
１６
Setup baud:
Send: AT+BAUD1
Receive: OK+Set:1
Note: If setup to Value 7, After next power on, module will not support any
AT Commands, until PIO0 is pressed, Module will change Baud to 9600.
4. Clear Last Connected device address
Send Receive Parameter
AT+CLEAR OK+CLEAR None
Notice: Only Central role is used.
5. Try connect to last succeeded device
Send Receive Parameter
AT+CONNL OK+CONN[Para1] Para1: L, E, F, N
L: Connecting
E: Connect error
F: Connect Fail
N: No Address
Notice: Only Central role is used.
If remote device has already connected to other device or shut down,
“OK+CONNF” will received after about 10 minutes.
6. Try connect an address
Send Receive Parameter
AT+CON[Para1] OK+CONN[Para2] Para1: Address
Like: 0017EA090909
Para2: A, E, F
A: Connecting
E: Connect error
F: Connect Fail
Notice: Only Central role is used.
If remote device has already connected to other device or shut down,