User Manual

2-2 Starting the Panel PC& O/S Installation

1. Connect the power to 12V DC power supply to 3 pins Terminal block (Phoenix Type)

2. Press the power on switch to start the Panel PC.

3. Press “DEL” to enter the CMOS setting and check the BIOS setup.

4. You may install your own O/S if it is not installed. When installing O/S for this Panel PC,

please follow the steps and use external equipment as Keyboard and USB DVD-ROM

(a) Please use external USB DVD-ROM to run the O/S and Driver setting (as picture showed

below).

(a) Please use external USB DVD-ROM to run the O/S and Driver setting (as

Connect to

Terminal block on PPC

Terminal Block Male Part

Terminal Block Female Part