Owner's manual
Table Of Contents
- Table of Contents
- Introduction
- SeaI/O Hardware Description
- SeaI/O Base and Expansion Modules
- SeaI/O Module Common Features
- SeaI/O Configurations & Specifications
- 410 Series – 16 Optically Isolated Inputs/16 Reed Relay Outputs
- 420 Series – 16 Optically Isolated Inputs/8 Form C Outputs
- 430 Series – 32 Optically Isolated Inputs
- 440 Series – 32 Reed Relay Outputs
- 450 Series – 16 Form C Relay Outputs
- 462 Series – 96 Channel TTL DB-78
- 463 Series – 96 Channel TTL 50-Pin
- 470 Series – 16 A/D, 2 D/A, 8 24V Outputs, 8 Isolated Inputs
- 520 Series – 8 Optically Isolated Inputs/8 High-Current Form C Outputs
- Power Options
- Hardware Configuration
- Wiring Options
- Mounting Options
- Accessories
- SeaMAX Application Suite
- SeaI/O Architecture
- Device Address Configuration
- Configuring the “Base” SeaI/O Module
- Configuring N-Series Expansion Modules
- Configuring an Ethernet Module (E-Series)
- MaxSSD Configuration & Diagnostics Utility
- Communicating Via Modbus
- Extended Modbus Command Set
- Developing Custom Applications Using SeaMAX API
- SeaMAX API
- Non Object-Oriented SeaMAX API
- IOCTL Calls and Functionality
- Using SeaMAX with Visual C++ 6.0
- Using SeaMAX with Visual Basic 6.0
- Example SeaMAX Programming Tasks
- CEthernet API
- Appendix A – Data Encoding Tables
- Appendix B – CRC Calculation
- Appendix C – SeaIO Model 462/463 Holding Register Set
- Appendix D – SeaMAX Data Types and Structures
- Appendix E – Troubleshooting
- Appendix F – How To Get Assistance
- Appendix G – Compliance Notices
- Warranty
© Sealevel Systems, Inc.
- 52 -
SeaI/O User Manual
D/A Outputs Tab
The “D/A Outputs” tab is useful for manually setting the digital to analog output
voltages. A preliminary diagnostics utility (see following page) has been provided to
verify proper hardware functionality.
The D/A outputs of the SeaI/O-470 are factory set for 0-10V. To configure the D/A
outputs for 0-5V, you will need to open the enclosure and set the correct jumpers.
Refer to the Hardware Configuration section of this manual for instructions on
opening the enclosure and accessing the correct jumpers.
To adjust a particular channel’s output voltage, drag the slider until the desired
voltage is displayed in the window on the right side. Also, you may type the desired
voltage directly into the voltage display and press the ‘Enter’ key.
NOTE:
The output voltage will not change until the ‘Enter’ key is pressed
or you have clicked on the window anywhere outside of the field.