Owner's manual
Table Of Contents
- Table of Contents
- Introduction
- SeaI/O Hardware Description
- SeaI/O Base and Expansion Modules
- SeaI/O Module Common Features
- SeaI/O Configurations & Specifications
- 410 Series – 16 Optically Isolated Inputs/16 Reed Relay Outputs
- 420 Series – 16 Optically Isolated Inputs/8 Form C Outputs
- 430 Series – 32 Optically Isolated Inputs
- 440 Series – 32 Reed Relay Outputs
- 450 Series – 16 Form C Relay Outputs
- 462 Series – 96 Channel TTL DB-78
- 463 Series – 96 Channel TTL 50-Pin
- 470 Series – 16 A/D, 2 D/A, 8 24V Outputs, 8 Isolated Inputs
- 520 Series – 8 Optically Isolated Inputs/8 High-Current Form C Outputs
- Power Options
- Hardware Configuration
- Wiring Options
- Mounting Options
- Accessories
- SeaMAX Application Suite
- SeaI/O Architecture
- Device Address Configuration
- Configuring the “Base” SeaI/O Module
- Configuring N-Series Expansion Modules
- Configuring an Ethernet Module (E-Series)
- MaxSSD Configuration & Diagnostics Utility
- Communicating Via Modbus
- Extended Modbus Command Set
- Developing Custom Applications Using SeaMAX API
- SeaMAX API
- Non Object-Oriented SeaMAX API
- IOCTL Calls and Functionality
- Using SeaMAX with Visual C++ 6.0
- Using SeaMAX with Visual Basic 6.0
- Example SeaMAX Programming Tasks
- CEthernet API
- Appendix A – Data Encoding Tables
- Appendix B – CRC Calculation
- Appendix C – SeaIO Model 462/463 Holding Register Set
- Appendix D – SeaMAX Data Types and Structures
- Appendix E – Troubleshooting
- Appendix F – How To Get Assistance
- Appendix G – Compliance Notices
- Warranty
© Sealevel Systems, Inc.
- 44 -
SeaI/O User Manual
Configuring an Ethernet Module (Continued)
NOTE:
If the module does not change or respond, the PC and the module
may be on different subnets. Proceed to the Recover Module
section on the following page.
Start MaxSSD (Start Æ All Programs Æ Sealevel SeaMAX Æ MaxSSD) and choose
the correct IP address to communicate with the “base” Ethernet SeaI/O module.
Ensure a successful Get operation (refer to the MaxSSD section on the following
pages for more information).
Set the slave ID of the “base” Ethernet SeaI/O module using the rotary switch or
software selection method discussed in the Setting Device Address section on the
previous pages. This guarantees that any expansion modules connected next will not
conflict with the “base” module. Perform another Get operation to verify that you
can communicate with the “base” Ethernet SeaI/O module at the new slave ID.
NOTE:
Configure the SeaI/O modules one at a time. Set the address to a
hardware slave ID other than “0” or a software slave ID other than
247, which avoids device conflicts during setup.
After the “base” Ethernet SeaI/O module is successfully communicating via
MaxSSD, you can proceed with adding SeaI/O expansion modules (N-series). Refer
to the Configuring Expansion Modules section on the previous pages.