User's Manual

14
OEM Integration Instructions
This device is intended only for OEM integrators under the following conditions
The module can be used to installation in other host. The antenna must be installed such that 20
cm is maintained between the antenna and users, and the transmitter module may not be co-
located with any other transmit or antenna. The module shall be only used with the integral
antenna(s) that has been originally tested and certified with this module. As long as 3
conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance
requirement with this module installed (for example, digital device emission, PC peripheral
requirements, etc.)
IMPORTANT NOTE
In the event that these conditions cannot be met (for example certain laptop configuration or co-
location with another transmitter), then the FCC authorization for this module in combination
with the host equipment is no longer considered valid and the FCC ID of the module cannot be
used on the final product. In these and circumstance, the OEM integrator will be responsible for
re-evaluating. The end product (including the transmitter) and obtaining a separate FCC
authorization. The final end product must be labeled in a visible area with the following:
Contains Transmitter Module FCC ID: 2ASGB-US142019” or
“Contains FCC ID: 2ASGB-US142019”.
Antenna Specification:
Antenna Name Frequency Band
(GHz)
TX Paths Max Peak Gain
(dBi)
RP-SMA Antenna (Ant
1)
2.4 ~ 2.5 1 5.0
PCB Antenna (Ant 2)
2.4 ~ 2.5 1 2.0
Note: The device can only use the Ant 1 When it is working at 2.5MHz Bandwidth.