User's Manual

Speedway Revolution Installation and Operations Guide Octane 4.11

Appendix C: Speedway xPortal Installation

Appendix D: Speedway Antenna Hub Installation

Speedway Antenna Hub Solution Checklist

Before starting, make sure that you have all the necessary and following items:

 1 Speedway Antenna Hub (IPJ-A6001-000) Required components (available

separately):

 1 Speedway Revolution R420 Reader with Octane firmware v4.10 or higher (IPJ-REV-

R420)

 1 GPIO Adapter for Antenna Hub (IPJ-A6051-000)

 RF Cables (various)

 Cat5 cables for control channel (not sold by Impinj)

 Antennas (various)

 MultiReader software version 6.8 or higher

 Optional – up to 3 additional Antenna Hubs

Figure D.1 Speedway R420 Reader with four antenna hubs and GPIO adaptor for

a total of 32 RF antenna ports.

Setting Up a Speedway Antenna Hub System

1) Check the Firmware Version on your Speedway R420 Reader.

a) Connect to Reader WebUI using a web browser

http://<reader name or IP address>

b) Log in to the Reader. The Default credentials are: