Installation Sheet

Imperial Cal Products, Inc.
Powered Liners Installation Detail Continued:
Figure 1:
Figure one shows the included
elbow transition from 7” diameter
round to 3 1/4” x 10” rectangular.
This transition is used to return
the filtered air back to inside the
kitchen either through the canopy
face of if applicable the soffit
above. The customer must
provide the appropriate length of
straight 7” round ducting that
connects the hood exhaust to the
elbow transition.
Figure 2
Figure two shows a typical air exit
terminating through the canopy
face. A customer supplied,
decorative 4” x 10” register cover
face plate should be used to finish
off the cut out opening.
Figure 3
Figure three shows a typical air
exit terminating through the soffit
face directly above the hood
canopy. Again the customer
must provide a 4” x 10” register
face plate.
Re-Circulating, (Non-Vented) Series: C2000SD2-NV
For use when unable to terminate exhaust ducting to outside the structure.
View from rear of the canopy.
Canopy Exit
Soffit Exit
Included
Not Included
NOTE: The C2000 NV Unit comes supplied with charcoal filters that will accumulate the
cooking grease and over time decrease the hoods performance. The amount and style of
cooking will dictate how often the filters should be replaced. This type of filter is designed
for replacement only. Contact Imperial to purchase proper replacement filters. The
C2000SD2-NV requires one 50 Watt Halogen (Par 20) flood light that must be purchased
separately.
Figure 1
Figure 2
4” x 10” Cover
Face Plate
4” x 10” Cover
Face Plate
Figure 3