Installation

Powered Liners Installation Detail Continued:
Figure 1:
Figure one shows the included elbow
transition from 7” diameter round to 3
1/4” x 10” rectangular. This transition is
used to return the filtered air back to
inside the kitchen either through the
canopy face of if applicable the soffit
above. The customer must provide
the appropriate length of straight
7” round ducting that connects the
hood exhaust to the elbow
transition.
Figure 2
Figure two shows a typical air exit
terminating through the canopy face. A
customer supplied, decorative 4” x 10”
register cover face plate should be
used to finish off the cut out opening.
Figure 3
Figure three shows a typical air exit
terminating through the soffit face
directly above the hood canopy.
Again the customer must provide a
4” x 10” register face plate.
Re-Circulating, (Non-Vented) Series: C2000SD2-NV
For use when unable to terminate exhaust ducting to outside the structure.
NOTE: The C2000 NV Unit comes supplied with charcoal filters that will accumulate
the cooking grease and over time decrease the hoods performance. The amount and
style of cooking will dictate how often the filters should be replaced. This type of filter
is designed for replacement only. Contact Imperial to purchase proper replacement
filters.
View from rear of the canopy.
Canopy Exit
Soffit Exit
Included
Not Included
Figure 1
Figure 2
4” x 10” Cover
Face Plate
4” x 10” Cover
Face Plate
Figure 3