Installation Guide

–5–
ENGLISHESPAÑOLFRANÇAIS
UNIT DIAGRAM
1. Control Dial
2. Temperature Control Panel
3. Adjustable Glass Shelves
4. Salad Bin Cover
5. Salad Bins
6. Freezer Door Shelves
7. Butter Compartment
8. Refrigerator Door Shelves
9. Leveling Feet
DOOR HANDLE INSTALLATION
The refrigerator must be disconnected before attempting the
installation of door handles.
Step 1: Install the two Phillips head screws into the door holes
and turn screws until fully in place.
Step 2: Position the door handle on the screws installed in
Step 1.
Step 3: Install screws at the hole located on the side of the
handle and turn screws until completely tight. Install
screw caps as shown in the figure above.
DOOR SWING REVERSAL (OPTIONAL)
It is advised that you determine if you need to reverse the door
swing and complete this procedure prior to installing
and turning on your refrigerator.
Note: These instructions are for changing the hinges from the
right side to the le side. If you wish to change the hinges back
to the right side, follow these same instructions and reverse all
references to le and right.
CAUTION:
To avoid injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
• Ensure the appliance is unplugged and empty.
• Adjust the two leveling feet to their highest position.
• Have something solid against which to rest the appliance.
This will be necessary when it comes to taking o the door
• Avoid laying the refrigerator completely flat on its back as
this may damage the cooling system.
TOOLS REQUIRED:
• Phillips screwdriver
• Allen Key
• Flathead screwdriver
STEP 1: REMOVE THE FREEZER DOOR
Using a flathead screwdriver, gently pry and li the right top
hinge cover and the le cover plate. Using a Phillip’s screw-
driver, unscrew the screws of the right top hinge. Remove the
upper hinge. Raise the freezer door upward to detach.
Right top
hinge cover
Le cover
plate
1
2
3
4
5
6
7
8
9