Use and Care Manual

4, Install the Seal.
(1) Stick 1’’x4/5’’x13 4/5’’ sponges to the condenser side
plate, for both left and right at the back side of TTW unit.
(2) Seal the Wall-sleeve inside.
a, Seal the internal back side of wall-sleeve by sponges.
b, Seal and stick the top and bottom inside back edge by
two 1’’x1 1/2’’x25’’ long and thick sponges.
c, Seal and stick the left and right inside back edge by two
1’’x1 1/2’’x13 4/5’’ shorter and thick sponges.
IMPORTANT: Be sure that, these seal sponges will not bl-
ock the back grille inlet opening. If they effect the air-inlet
or outlet, cut them to the suitable dimension or thickness.
5, Set the tilt angle backward.
(1) Cut two suitable dimension of pearl seal cottons, and
stick to the front bottom of wall-sleeve.
(2) Be sure that, there will be a 3 tilt angle backward
of the sleeve and unit, when slide in the TTW unit.
6, Install the grounding wire.
a, Install screw end of ground wire into inside of sleeve
according to preparation instruction.
b, Remove the second screw from left side of unit, and
remove the screw plastic washer.
c, Screw the other end of the ground wire into the unit.
Make sure the toothed washer is against the cabinet.
Condition2: Install the back grille to the TTW
7, Gently slide the TTW unit into wall-sleeve. Be sure that,
the unit should be a 3 tilt angle backward.
If necessary, add some pearl cotton to the unit bottom.
In case where the dual intake grille cannot be mounted di-
rectly to the sleeve. It is desirable to attach the grille to the
back of the TTW unit to the hole pre-drilled in the unit.
1, Prepare the wall-sleeve followed the Condition 1 part.
2, Stick 1’’x4/5’’x13 4/5’’ sponges to the condenser side
plate, for both left and right at the back side of TTW unit.
3, Install the back grille to the back side of the TTW unit to
the hole pre-drilled. Take attention the remark on back grille
including in the new unit, if it appears.
a, Put the [OUTSIDE] remark toward to outside, and let the
arrow remark toward upside.
b, new to the TTW unit
Wall-Sleeve
Rear
Front
3
7