Use and Care Manual

16
ENGLISH ESPAÑOL FRANÇAIS
2. Push the TIMER OFF button again to set desired
Auto-o time. Each time you press the button, the
time increases in 30 minutes increments, up to 10
hours, then at 1 hour increments up to 24 hours.
3. Aer setting the TIMER OFF, there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
aer approximately another 2 seconds, the signal
“h” will disappear and the set temperature will
re-appear on the LCD window.
EXAMPLES OF TIMERS:
AUTO ON: If you’d like your home or oice to be
cool aer returning from an event or running er-
rands, schedule the machine to turn on and cool the
room for your arrival.
To set the machine to start in 6 hours, push the
TIMER ON button. The display will read “h”; push
the TIMER ON button until the display reads “6.0”.
Wait 3 seconds and the program will be activated
once the LED resumes displaying the room tempera-
ture.
AUTO OFF: Your children rarely turn the air condi-
tioning o during the day and you leave for work
before they leave for school. Consider scheduling
the unit to turn o automatically.
To set the machine to turn o in 1 hour, push the
TIMER OFF button. The display will read “h”; push
the TIMER OFF button until the display reads “1.0”.
Wait 3 seconds and the program will be activated
once the LED resumes displaying the room tempera-
ture.
COMBINED TIMERS: You can use the Auto On and
Auto O functions simultaneously. An example of
this feature is to turn o the unit in 1 hour when the
kids leave for school and turn it on in 6 hours just
before you return from work.
(See above.)
SLEEP (Economy) operation
• Press this button, the selected temperature will in-
crease by 2°F /1°C aer 30 minutes. The tempera-
ture will then increase by another 2°F /1°C aer an
additional 30 minutes.
• The new temperature will be maintained for seven
hours before it returns to the originally selected
temperature, at which point Sleep mode ends
and the unit will continue to operate as originally
programmed.
• NOTE: This feature is unavailable under FAN or
DRY modes.
PMTS (FOLLOW ME) Feature:
• NOTE: This feature can be activated from the
remote controller ONLY. The remote controller acts
as a remote thermostat allowing for the precise
temperature control at its location.
• To activate the Follow Me/Temp Sensing feature,
point the remote controller towards the unit and
press the PMTS/Follow Me button. The remote
displays the actual temperature at its location.
The remote controller will send this signal to the
air conditioner every three minutes interval until
press the Follow Me/Temp Sensing button again.
• If the unit does not receive the PMTS signal during
any seven-minute interval, the unit will beep to
indicate the PMTS mode has ended.
SHORTCUT Feature:
• This button is one-touch preset for your favorite
settings.
• The same button is used to store the current set-
tings or recall previous settings.
• The first time the button is pressed, the unit will
operate on AUTO mode, 78ºF and AUTO fan speed
• Pushing it a second time should revert to all
previous settings including operating mode,
temperature, fan speed level and sleep feature (if
activated)
• To store the current mode, temperature, fan speed
level, etc. into memory, hold the button for at least
2 seconds.