User Manual

26
Problem Solution
I can’t adjust the brightness of the
modeling light from the controller.
The Venture TTL 600 monolight is set to either modeling light mode F3-2 or F3-3.
When set to these modeling light modes, the modeling light brightness is set by
changing the ash output power.
To adjust the modeling light brightness from the Venture controller, set the Venture
TTL 600 to either modeling light modes F3-0 or F3-1.
TTL mode is selected on the controller,
but the monolight is in manual mode,
and its LCD screen doesn’t display auto
(AU) mode.
Make sure the Venture TTL controller and the Venture TTL 600 monolight are set to
the same channel and ID number.
Press the controller's ENTER button to restore the monolight’s TTL settings.
Troubleshooting (continued)