User Manual

11
The Venture Wireless TTL Controller
runs on two AAA alkaline, lithium, or
NiMH batteries.
1. Open the battery compartment
door by pressing on the tab and
ipping the door open.
2. Insert two AAA batteries into the
compartment with the orientation
indicated by the diagram inside
the compartment.
3. Close the battery compartment
door until it clicks shut.
Note: During long periods of inactivity,
remove the batteries from the battery
compartment.
1. With the power of all devices
turned off, slide the controller’s
mounting foot into the camera’s
hot shoe.
2. Secure the controller by
tightening the locking wheel.
Installing the Batteries Mounting the Controller