User Manual

A multivoltage 100–240 V AC, 50/60 Hz
charger is included with the Venture TTL 600
for the rechargeable Li-ion battery.
To charge the battery:
1. Plug the AC cord into a wall outlet, and
the charger’s indicator light will glow
green to indicate that power is being
received.
2. Connect the DC cord to the battery. The
indicator light will glow red to indicate
the battery is charging, and green to
indicate that the battery is charged.
To install the battery:
1. Slide the insertion guides into the slots
in the battery compartment. Make sure
the metal contact plates on the battery
are aligned with the contacts in the
battery compartment.
2. Press the battery into place until it
clicks shut.
Note: Impact recommends fully charging
the battery before its initial use and after an
extended period of inactivity (more than two
months).
If the unit is left unused for an extended
period of two weeks or more, or if the unit
has been used predominately at low-power
settings, set the power to maximum and
switch the monolight on (with the modeling
lamp off) for at least 10 minutes. This will
help preserve the life of the capacitors.
When not in use, the battery loses
approximately 3%–14% of its charge per
month. To maintain your battery, recharge it
every 2–3 months, even if it’s not in use.
Charging and Installing the Battery