User Manual

9
Precautions ⚠⚡
Before using the VE-TTL, please read
the following safety notices carefully
and thoroughly. This will ensure safe
use and to help prevent damage to
your ash and injury to yourself or
others.
Prolonged, fast shooting at
fast recycling rates might cause
overheating. The Venture TTL’s
protection circuit will shut the unit off
for approximately 5–10 minutes.
Warning
• There are no user-serviceable
parts inside the unit. Only
qualied service engineers
should access the inside of the
case. Due to the high-voltage
circuitry inside this device, do
not attempt to disassemble or
repair the unit yourself. Doing
so will void the warranty.
• Do not re the ash at close
range directly into the eyes of
people or animals. This can
cause damage to the retina and
may even lead to blindness.
• If the ashtube or modeling light
becomes cracked or damaged in
any way, replace immediately.
• Frequent use of HSS will have
an adverse effect on the lifetime
of the ashtube.
• Do not use or store the Venture
TTL 600 in ammable conditions
(such as environments
containing ammable gases or
liquid chemicals). This could
damage the ash, start a re, or
cause an electric shock.
• Do not clean the Venture TTL 600
with agents containing corrosive
or ammable substances such
as paint thinner, benzene, or nail
polish remover.
• This product is not water
resistant. Keep it away from
rain, snow, humidity, and general
moisture.
• Use only the correct,
recommended battery.