User Manual

4
1. Dual-function COMMAND dial
Adjusts light output from 1/1
(highest) to 1/128 (lowest) in
1/3-stop increments.
Sets operating and modeling
light modes.
Adjusts modeling light
brightness (when used with
the MODEL button).
2. MODEL button
Turns the modeling light on
or off.
Adjusts the modeling light
power output (mode F3-0 or
F3-1)
3. SOUND/FN button
Turns sound on and off.
Activates Modeling Light
mode (F3) and Operating
mode (F4).
4. CH/ID button
Press to select channels 1–9.
Press and hold while rotating
COMMAND dial to select
groups A, B, or C.
Press and hold while turning
power on to select Personal
ID codes.
5. P.CELL button
Turns optical sensor mode on
and off.
Press and hold while turning
the power on to restore
factory presets.
6. Optical Slave Eye indicator
Glows green to indicate that
the optical sensor mode is
enabled.
7. 1/4″ (6.35 mm) sync port
Connects to the camera via
the included sync cable.
8. CHG indicator
Glows red to indicate the
monolight is ready to re.
Glows blue to indicate Power
mode operation.
9. TEST button
Fires a test ash.
Overview